Can the AC plug mold be used on auto parts?

Can the AC plug mold be used on auto parts?

　　 In automotive parts, wireless antenna products often use this hardware accessory, power plug mold sports jacket, today Xiaobian will introduce the production process and abrasive tools of such products in detail. Name: Plug sleeve, brass, thickness 0.25 Some friends will think it is made by die-casting, I think it is not. The correct technique is copper pipe-turning and cutting-die stamping-pressing.

　　 1. Purchase a copper pipe and use an automatic lathe to process it to a suitable length. The exact length needs to be determined by proofing.

　　 2. Moulded vent groove. Because the grooves on all sides are thin and the outer diameter of the product is only 8.5, the strength of the mold is very weak.

Generally, there are three punching methods for four rectangular holes: a: punching one hole at a time requires four consecutive punching holes. Since the four holes are evenly distributed, it is necessary to fix the rotation by positioning before drilling, which is very inefficient. Due to large product tolerances, some factories operate very fast and rely on workers to control the angle according to their own feelings. They don't need positioning. Despite the speed, the offer is higher. Plug-in structure, the upper die is a punch, and the lower die is 7-shaped, even if there is no die frame, the mandrel can be fixed. Improvement method: Clamp the copper sleeve with paper towels, and push the copper sleeve to rotate automatically through the up and down, left and right fitness exercises of the high-speed punch.

　　B. The second method: punch long holes up and down, two at a time, and 90 degrees. Mold structure: it can slide up and down relatively, or slide left and right. C. Three methods: place the product vertically, slide the guide rail, and then punch the four slots together. This method is indeed effective and very efficient. Designed a complete plan. Key point: The gaps on the wound should be good to avoid burrs, otherwise it will be difficult to pick up the goods. The waste should fall smoothly and the core should explode. The surrounding rail slider can be driven by the lower die wedge drive, or 4 small cylindrical drives can be used.

　　 The tool previously designed by the small knitting machine is fixed on the frame, and the large cylinder is installed in the center of the bottom of the frame. The hydraulic cylinder moves up and down, and drives four sliders to work simultaneously through the lever mechanism.

　　 3. Press and press. Using a small desktop press, fix the plate to the upper mold, install the tungsten steel sleeve on the lower mold, and then insert the copper sleeve into the tungsten steel sleeve. The angle r in the bushing is pushed out relative to the copper bushing.