How to avoid deformation in the manufacture of AC plug molds?

How to avoid deformation in the manufacture of AC plug molds?

　　The plastic AC plug mold factory often encounters deformation during the manufacture of the AC plug mold in the manufacture of the AC plug mold. This problem is simple and simple, but how to do it? What are the specifics below? The first thing to say is: the structure of the plastic AC plug mold factory, AC plug mold. Some points to deal with:

(1) The thickness of the product should be as uniform as possible.

(2) The design of the cooling system should make the temperature of each part of the mold cavity of the AC plug uniform, the casting system should make the material flow symmetrical to avoid warpage caused by the different flow direction and shrinkage rate, and appropriately thicken the shunt of the difficult-to-form part , Mainstream, try to eliminate the density difference, pressure difference and temperature difference in the cavity.

　　 (3) The thickness of the transition zone and the corner of the part should be smooth enough, and must have good demoldability, such as increasing the mold release margin, improving the polishing of the mold surface, and the ejection system to maintain balance.

　　 (4) Exhaust should be good.

　　 (5) Adjust the wall thickness of the part to compensate for the deformation, or add ribs to enhance the warpage resistance of the part.

　　 (6) Plastic AC plug mold factory's AC plug mold has insufficient material strength